Capacitors in Series and Parallel, Explained

By Anatolie · Updated 2026-11-21

Combining capacitors follows the same two rules as combining resistors, but the other way round: capacitors in parallel simply add, and capacitors in series combine like resistors in parallel. Once you know why, the rules are hard to mix up.

The two rules

Parallel: Ctotal = C1 + C2 + C3 + …
Series: 1 ÷ Ctotal = 1 ÷ C1 + 1 ÷ C2 + 1 ÷ C3 + …

For exactly two capacitors in series there's a shortcut: Ctotal = (C1 × C2) ÷ (C1 + C2), "product over sum".

Why they're the opposite of resistors

A capacitor's value grows with the area of its plates and shrinks as the gap between them widens. Wiring capacitors in parallel joins their plates side by side, which is like one capacitor with more plate area, so the values add. Wiring them in series stacks the gaps, which is like one capacitor with a thicker dielectric, so the total drops — and always ends up smaller than the smallest capacitor in the chain.

ComponentIn seriesIn parallel
Resistorsaddreciprocals add
Inductorsaddreciprocals add
Capacitorsreciprocals addadd

Worked examples

Parallel. 10 µF and 22 µF in parallel: 10 + 22 = 32 µF.

Series, two values. The same pair in series: (10 × 22) ÷ (10 + 22) = 220 ÷ 32 ≈ 6.9 µF — below the smaller of the two, as expected.

Equal values in series. Two identical capacitors in series give half the value of one: two 100 µF parts make 50 µF. Three identical ones give a third.

The series/parallel capacitor calculator takes any number of values in µF and gives both totals at once. Its resistor twin is the series/parallel resistor calculator.

Keep the units consistent

Mixing µF, nF, and pF is the usual source of an answer that's off by a factor of a thousand. Convert everything to one unit first: 1 µF = 1,000 nF = 1,000,000 pF, so 100 nF is 0.1 µF and 470 pF is 0.00047 µF. A ceramic capacitor marked "104" is 100 nF — the capacitor code decoder and the guide to capacitor codes cover the markings.

Voltage ratings

In parallel, every capacitor sees the full voltage, so the combination is only safe up to the lowest voltage rating in the group.

In series, the voltage is shared, but not evenly unless the capacitors are identical: each one takes a share inversely proportional to its capacitance, so the smallest capacitor carries the most voltage. Series connection is sometimes used to build a higher voltage rating out of lower-rated parts, but with electrolytic capacitors, differences in leakage current unbalance the split over time. The usual fix is a balancing resistor of equal value across each capacitor. Electrolytics are also polarised, so in any combination each one must still face the right way.

Tolerance

Capacitor values are loose compared with resistors — ±10 % to ±20 % is normal for electrolytics, and some ceramics lose a large share of their capacitance under DC bias. Treat a calculated total as nominal, and leave margin in anything timing-critical. To see what a capacitance does in a circuit, the RC time constant calculator turns R and C into charge and discharge times.